Changing the default file save location on the USB drive
By default, the oscilloscope saves image, waveform, and setup files to the top
directory of the USB drive. Use this procedure to select a different default save
folder on the USB drive in which to save files.
1. Push the Save/Recall front-panel button.
2. Push the File Utility side-menu button.
3. Use the Multipurpose knob to navigate to and highlight a folder in which to
save files.
4. Push the Change Folder side-menu button. Saved files will now be saved to
this location.
Default save folder location rules
■
The new save folder location remains in effect until:
■
A new location is set with the Change Folder button.
■
The oscilloscope is powered down. The save location changes back to the
top level of the USB drive.
■
The following actions do not change the file save location. The oscilloscope
shows an error message when it tries to save the file to a location that it
cannot find. Use the Change Folder function to change the working folder
location to an existing folder and try the save operation again.
■
Deleting the save location folder.
■
Removing or inserting a USB drive.
■
Pushing the Default Setup front-panel button.
Using the USB file utility functions
TBS2000B Series Oscilloscopes User Manual 141
To Next Page
Loading...
Need help?
General
