Turning DHCP on or off Wi-Fi
A Dynamic Host Configuration Protocol (DHCP) network automatically
allocates network IP addresses and settings to DHCP-enabled instruments like the
TBS2000B Series oscilloscope. Use this procedure to turn the oscilloscope
DHCP-capability on or off.
Prerequisites:
■
A supported Wi-Fi dongle is connected to the oscilloscope and is turned on.
See Turning Wi-Fi on or off on page 157.
■
The network to which you are connecting must be DHCP-enabled.
1. Push Utility front-panel button.
2. Push the Config side-menu button.
3. Use the Multipurpose knob to select and click Wi-Fi Config.
4. Highlight DHCP.
5. Push the Multipurpose knob to select ON. The oscilloscope takes a few
moments to request and load the IP address form the DHCP server. The LAN
Test menu items should now show OK, and the network connection icon
(upper right edge of screen) should be on (white).
6. Push the knob again to turn DHCP Off.
Setting up the Wi-Fi network
TBS2000B Series Oscilloscopes User Manual 161
To Next Page
Loading...
Need help?
General
