Greensmaster 3150 Page 2 -- 1 Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of Contents
PRODUCT RECORDS 1.........................
MAINTENANCE 1..............................
EQUIVALENTS AND CONVERSIONS 2...........
Decimal and Millimeter Equivalents 2............
U.S. to Metric Conversions 2...................
TORQUE SPECIFICATIONS 3...................
Fastener Identification 3.......................
Using a Torque Wrench with an Offset Wrench 3..
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Inch Series). 4...............
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Metric Fasteners). 5..........
Other Torque Specifications 6..................
Conversion Factors 6.........................
Product Records
Insert a copy of the Operator’s Manual and Parts Cata-
log for your Greensmaster 3150 at the endof this chap-
ter. Additionally, if any optional equipment or
accessorieshavebeen installedto yourmachine,insert
the Installation Instructions, Operator ’s Manuals and
PartsCat alogs forthose optionsat theend ofthischap-
ter.
Maintenance
Maintenanceproceduresandrecommendedservicein-
tervals for the Greensmaster 3150 are covered in the
Traction Unit Operator’s Manual. Maintenance proce-
dures and recommended service intervals for the
Greensmaster Cutting Units are covered in the Cutting
Unit Operator ’s Manual. Refer to these publications
when performing regular equipment maintenance. Re-
fer to the Engine Operator’s Manual for additional en-
gine specific maintenance procedures.
Product Records
and Maintenance
To Next Page
Loading...
Need help?
General
