Greensmaster 3150Hydraulic System Page 4 -- 46
Steering Control Valve Test
1160 PSI
Steering Cylinder
PET
LR
STEERING
VALVE
4.5
TO CONTROL
MANIFOLD
PORT P2
TO CONTROL
MANIFOLD
PORT ST
FROM GEAR
PUMP
PLUG
TURNED FOR
RIGHT TURN
(CYLINDER ROD
FULLY EXTENDED)
Procedure for Steering Control Valve Test:
1. Make sure the hydraulic reservoir is full.
2. Make sure hydraulic oil is at normal operating tem-
peraturebyoperatingthemachineforapproximatelyten
(10) minutes.
3. Drive machine slowly in a figure eight on a flat level
surface.
A. There should be no shaking or vibration in the
steering wheel or rear wheel.
B. Steering wheel movements should be followed
immediately by a corresponding rear wheel move-
ment without the steering wheel continuing to turn.
4. Stop the machine with the engine running. Turn
steering wheel with small quick movements in both
directions.Letgoofthesteeringwheelaftereachmove-
ment.
A. The steering wheel must go back immediately to
the neutral position.
B. The steering wheel should not continue to turn.
To Next Page
Loading...
Need help?
General
