Workman 1100/1110/2100/2110 Page 7 – 7 Chassis, Wheels, and Brakes (Rev. B)
Adjustments
Adjust Brakes (Workman 1100 and 2100, Serial Number Below 230000000)
CAUTION
Before and after adjusting the brakes, always
check the brakes in a wide open area that is flat
and free of other persons and obstructions.
1. While driving the machine, depress brake pedal.
Both wheels should lock equally.
2. Park machine on a level surface. Make sure engine
is off. Remove key from ignition switch.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
3. Jack front of the vehicle off the ground.
4. Tighten cable adjusting screw, located beneath the
floor panel, until the cables are snug in the brake equal-
izer. Do not overtighten. There should be some free play
in the brake pedal before the brake engages. The actua-
tor levers on the brakes should fully return when the
brake pedal is released.
1. Cable adjusting screw 2. Brake equalizer
Figure 1
2
1
and Brakes
Chassis, Wheels,
To Next Page
Loading...
Need help?
General
