Triumph Street Twin User Manual

Maintenance and Adjustment
115
Brakes
Warning
Brake pads must always be replaced
as a wheel set. At the front, where two
calipers are fitted on the same wheel,
replace all the brake pads in both
calipers.
Replacing individual pads will reduce
braking efficiency and may cause an
accident.
After replacement brake pads have
been fitted, ride with extreme caution
until the new pads have 'broken in'.
Brake pads must be inspected
in accordance with scheduled
maintenance requirements and replaced
if worn to, or beyond the minimum
service thickness.
1
2
1. Brake pads
2. Minimum thickness line
Bonneville T100 (all models) and
Bonneville T120 (all models)
If the lining thickness of any brake
pad (front or rear brakes) is less than
1.5 mm (0.06 in), that is, if the brake pad
has worn down to the bottom of the
grooves, replace all the brake pads on
that wheel.
Street Scrambler, Speed Twin,
Street Twin and Thruxton RS
If the lining thickness of any brake pad
is less than 1.0 mm (0.04 in) (front) or
1.5 mm (0.06 in) (rear), replace all the
brake pads on that wheel.
Note
Street Scrambler, Speed Twin and
Street Twin Only
An area of the front brake backing
plate is raised and will cause the front
brake to squeal as notification to the
rider when the brake pad(s) are below
the minimum thickness. Replace all the
brake pads on that wheel.

Triumph Street Twin Specifications

General

Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Displacement	900 cc
Bore x Stroke	84.6 x 80 mm
Compression Ratio	11.0:1
Max Torque	80 Nm @ 3, 800 rpm
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Gearbox	5-speed
Frame	Tubular steel, twin cradle
Front Tire	100/90-18
Rear Tire	150/70 R17
Dry Weight	198 kg
Wet Weight	216 kg
Fuel Consumption	4.1 l/100 km
CO2 Emissions	93 g/km
Max Power	65 PS (64 bhp) @ 7, 500 rpm
Exhaust	Brushed 2 into 2 exhaust system with twin brushed silencers
Front Suspension	41mm forks
Rear Suspension	Twin shocks with adjustable preload
Front Brakes	Single 310mm disc, Nissin 2-piston floating caliper
Rear Brakes	Single 255mm disc, Nissin 2-piston floating caliper
Front Wheel	Cast aluminium alloy, 18 x 2.75 in
Rear Wheel	Cast aluminium alloy, 17 x 4.25 in
Seat Height	765 mm
Fuel Tank Capacity	12L
Width (Handlebars)	780 mm
Wheelbase	1450 mm
Rake	25.1 °
Trail	102.4 mm