EasyManuals Logo

Triumph Street Twin User Manual

Triumph Street Twin
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
General Information
67
Centre Stand (if fitted)
Caution
Do not use body panels or the seat
as a handhold when placing the
motorcycle on the centre stand as this
will cause damage.
1
1. Centre stand
To set the motorcycle on the centre
stand:
Hold the motorcycle upright.
Step down firmly on the foot finder
part of the stand.
Lift the motorcycle up and to the
rear using the rear frame as a
handhold.
For instructions on safe parking, refer
to the How to Ride the Motorcycle
section.
Side Panels
All Models except Street Scrambler
citf
1
2
2
1. Side panel (right hand shown)
2. Grommets
The right side panel can be removed to
gain access to the adjustment tool and
the rear brake fluid reservoir.
To remove either side panel:
Grasp the panel firmly and pull the
panel away from the motorcycle
until it is free from the three
retaining grommets (leaving the
grommets in place).
To refit either side panel:
Position the three locating dowels to
the grommets, then press firmly to
secure the panel.
Finally, grasp the panel and make
sure that it is fully retained.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Street Twin and is the answer not in the manual?

Triumph Street Twin Specifications

General IconGeneral
Engine TypeLiquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Displacement900 cc
Bore x Stroke84.6 x 80 mm
Compression Ratio11.0:1
Max Torque80 Nm @ 3, 800 rpm
Fuel SystemMultipoint sequential electronic fuel injection
Final DriveChain
ClutchWet, multi-plate assist clutch
Gearbox5-speed
FrameTubular steel, twin cradle
Front Tire100/90-18
Rear Tire150/70 R17
Dry Weight198 kg
Wet Weight216 kg
Fuel Consumption4.1 l/100 km
CO2 Emissions93 g/km
Max Power65 PS (64 bhp) @ 7, 500 rpm
ExhaustBrushed 2 into 2 exhaust system with twin brushed silencers
Front Suspension41mm forks
Rear SuspensionTwin shocks with adjustable preload
Front BrakesSingle 310mm disc, Nissin 2-piston floating caliper
Rear BrakesSingle 255mm disc, Nissin 2-piston floating caliper
Front WheelCast aluminium alloy, 18 x 2.75 in
Rear WheelCast aluminium alloy, 17 x 4.25 in
Seat Height765 mm
Fuel Tank Capacity12L
Width (Handlebars)780 mm
Wheelbase1450 mm
Rake25.1 °
Trail102.4 mm

Related product manuals