Triumph Street Twin User Manual

Cleaning and Storage
156
Cleaning of the Exhaust
System
All parts of the exhaust system of your
motorcycle must be cleaned regularly to
avoid a deterioration of its appearance.
These instructions can be applied to
chrome, brushed stainless steel and
carbon fibre components; matt painted
exhaust systems should be cleaned as
above, noting the care instructions in
the Matt Paintwork section previously.
Note
The exhaust system must be cool before
washing to prevent water spotting.
Washing
Wash as previously described.
Make sure that no soap or water enters
the exhausts.
Drying
Dry the exhaust system as far as
possible with a soft cloth or chamois
leather. Do not run the engine to dry
the system or spotting will occur.
Protecting
Caution
The use of products containing
silicone will cause discolouration of the
chrome and stainless steel parts and
must not be used.
The use of abrasive cleaning products
will damage the finish and must not be
used.
When the exhaust system is dry, apply
a suitable proprietary motorcycle
protection spray onto the surface,
following the manufacturer’s
instructions.
It is recommended that regular
protection be applied to the system as
this will both protect and enhance the
system's appearance.

Triumph Street Twin Specifications

General

Engine Type	Liquid-cooled, 8 valve, SOHC, 270° crank angle parallel twin
Displacement	900 cc
Bore x Stroke	84.6 x 80 mm
Compression Ratio	11.0:1
Max Torque	80 Nm @ 3, 800 rpm
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	Chain
Clutch	Wet, multi-plate assist clutch
Gearbox	5-speed
Frame	Tubular steel, twin cradle
Front Tire	100/90-18
Rear Tire	150/70 R17
Dry Weight	198 kg
Wet Weight	216 kg
Fuel Consumption	4.1 l/100 km
CO2 Emissions	93 g/km
Max Power	65 PS (64 bhp) @ 7, 500 rpm
Exhaust	Brushed 2 into 2 exhaust system with twin brushed silencers
Front Suspension	41mm forks
Rear Suspension	Twin shocks with adjustable preload
Front Brakes	Single 310mm disc, Nissin 2-piston floating caliper
Rear Brakes	Single 255mm disc, Nissin 2-piston floating caliper
Front Wheel	Cast aluminium alloy, 18 x 2.75 in
Rear Wheel	Cast aluminium alloy, 17 x 4.25 in
Seat Height	765 mm
Fuel Tank Capacity	12L
Width (Handlebars)	780 mm
Wheelbase	1450 mm
Rake	25.1 °
Trail	102.4 mm