2.4 Viewing Sensor Data
The Sensor Data panel lists the standard and optional sensors monitored by iCOM and the current reading of each sensor.
• Touch , then > Sensor Data. The SENSOR DATA panel opens.
A secondary panel displays the DAILY SENSOR READING SUMMARY, which shows temperature, humidity and
dew point readings for the cooling unit.
NOTE: Depending on the type of thermal management unit, included components, and control settings of your
system, the options on your iCOM display may differ.
2.5 Managing Run Hours for a Component
You can view the run hours for components on a cooling unit, set the total run time limit, and reset total run hours to zero.
1. Touch , then > Total Run Hours. The RUN HOURS panel opens and the current hours for each
component are listed in the Total Run Hours column. To reset the total run hours to zero, see Setting Run Hours
to Zero below.
2. Use the slider to set the total run time limit for each component, then touch Save. The limits are set.
NOTE: Depending on the type of thermal management unit, included components, and control settings of your
system, the options on your iCOM display may differ.
2.5.1 Setting Run Hours to Zero
1. On the RUN HOURS panel, touch to check each box in the Total Run Hours column next to the component(s) to
reset. The Set to Zero button becomes available.
2. Touch Set to Zero. The total run hours for selected component(s) is set to zero.
2 User Operation
17
To Next Page
Loading...
Need help?
General