™
Page 48 of 81
6 Loc3-10Tx Transmitter
WARNING
Alkaline Batteries – insert alkaline batteries (x12) as shown:
6.2.3 Rechargeable Batteries
● Do not attempt to replace the rechargeable batteries or remove battery covers – return to Vivax-Metrotech or a Vivax-
Metrotech approved service centers for replacement.
WARNING
Use only Vivax-Metrotech recommended charger.
6.2.4 Re-tting the Battery Tray
To close the battery tray – slide the transmitter (TX) onto tray, it will locate itself in the correct position, then close the catches.
FUSE
Push up button underneath the catch – while holding that up push
in the bottom of the catch until you hear a positive “click”.
6.2.5 Rechargeable Battery Pack Charging and Disposal
Follow instructions detailed in the General Safety & Care Information section of this document.
Only use the battery charger supplied. Using a unapproved charger may damage the battery pack and could cause overheating.
To charge, the rechargeable batteries pack must be connected to the transmitter. Connect the mains charger to the charging
socket on the side of the transmitter and connect the charger to a suitable mains socket. Or if needed rechargeable tray can be
charged independently.
The LED on the charger will show a red light indicating that the charge cycle is in progress. When the batteries are fully charged
the LED will change to green.
NOTE
Rechargeable pack cannot be charged from a 12V DC source.
To Next Page
Loading...
Need help?
General
