™
Page 65 of 81
7 Loc3-5Tx Transmitter
2. Screen will show a list of frequencies available, with the central one in a box.
Frequency Menu
SD-USA
FF Low
FF High
3. Pressing the " " or " " pushbuttons, you can scroll up or down through the available frequencies.
4. Once the wanted frequency is inside the box, press “f” pushbutton to select or deselect the frequency. An “x” will appear in
the box for a selected frequency.
Frequency Menu
SD-USA
FF Low
FF High
5. After selecting the frequencies, press the "i" pushbutton again to exit the “Frequency Menu” and return to the main display.
6. A particular frequency in the chosen list of frequencies can be selected from the main display screen by pressing the “f”
pushbutton until the wanted frequency is displayed at the top of the main screen.
7.4.3 Multi-frequency Mode for Direct Connection
This feature can be used when user wants to energize on target two/three frequencies at the same time. Mainly, it can be used
when user is not sure which frequency can be impressed better into the target. Multi frequency mode is not available in Fault
Find and SD modes.
NOTE
● When using multi frequency mode, total power will be split between the activated frequencies.
● The frequencies have to be available in the main menu.
To enter the "Multi Freq. Setup" menu, proceeds as follows:
1. Press "i" pushbutton four times to get to the "Multi Frequency" screen and press “f” pushbutton to activate the multi
frequency mode. An “x” symbol will appear indicate the multi frequency mode is activated. Press “f” pushbutton again to go
in “Multi Freq. Setup” screen to choose the frequencies.
Volume
Voltage
Resistance
Multi Frequency
LCD Contrast
Bluetooth Menu
Frequency Menu
To Next Page
Loading...
Need help?
General
