Joystick Inboard Docking
calibration
NOTICE! Only available for inboard installations.
• Calibration may be done in either direction, port or starboard, at one station.To be performed in calm weather
conditions.
• Calibration is carried out in two steps.
• Make sure there is sufficient space for maneuvering the boat.
• The Idling speed calibration might influence the docking feature. Regain good docking function by performing
a Joystick Inboard Docking calibration again.
IGNITION IGNITION
START/STOPSTART/STOP
1. Move control to
neutral.
2. Turn the ignition on. 3. Start the engines. 4. DOCKING: press and
hold at least 5 seconds.
NOTICE! If only one of
the two steps is to be
adjusted, both steps
must still be confirmed.
5. Buzzer and light
confirm start of
calibration.
6. Docking calibration
started.
(7). Confirm previous
setting by leaving the
Joystick centered and
push DOCKING.
8. Keep Joystick in its
outermost side position
until confirmation in step
11.
9. Compensate boat movements with the Joystick by
rotating knob and moving it forward-backward.
10. The boat must move straight abeam.
Calibration and Settings
134 47708638 09-2016 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
