Drive Straight calibration
NOTICE! This calibration only needs to be performed if the boat does not travel straight after mechanical
installation.
1. Move all controls to
neutral.
2. Turn the ignition on. 3. THROTTLE ONLY:
press and hold for at
least 5 seconds.
4. Turn the steering wheel
to enter Calibration mode.
Drive Straight Calibration
started. Keep speed below
planning threshold and the
direction straight forward.
5. Manufacturer
Calibrations > Rudder
Steering.
6. Follow instructions on
screen.
7. If rudder end positions
are calibrated: Start
engines to perform
Drive Straight
Calibration
8. Follow instructions on
screen.
7. Press THROTTLE
ONLY to confirm rudder
position.
8. Ignition must be
turned off for at least 15
seconds to confirm the
calibration.
Calibration and Settings
136 47708638 09-2016 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
