DPU 130Le 14 Appendix
Operator's manual
105
14 Appendix
14.1 Display texts
If you have set the display language in the configuration menu to numerical code
display, the meaning of the different numerical codes can be found in the
following table:
Code Designation Code Designation
0 Self-test 30 Warm up ...
1 IR address 31 Start error
2 Diagnose 32 Enter PIN
3 Setup 33 Error
4 Error code 34 Wait..
5 Voltage 35 Error decoder
6 Temperature 36 OK
7 Engine speed 37 Start
8 IR transfer 38 Ready to start
9 SW version 39 Last error
10 LED signal 40 Exit
11 Turn-off time 41 Address comp.
12 Monitoring 42 Overload sensor
13 PIN 43 Machine
14 Setup PIN 44 Overload
15 Error memory 45 Wrong address
16 Operation hours 46 Wrong sender
17 Start-up 47 Warning
18 Test mode 48 Battery
19 Continue w. ON 49 Check
20 Select language 50 Cooling...
21 Oil pressure 51 Temp. sensor
22 Automatic start 52 Charge cont./St.
23 Excess temp. 53 Diesel valve
24 Shutdown 54 Gas adjuster
25 Charge control 55 Overvoltage
26 Charge con./Gen. 56 Machine number
27 Air cleaner 62 °C
28 Oil pres. sw. 63 rpm
29 Preheat...
To Next Page
Loading...
Need help?
General
