8 Use and operation DPU 130Le
59
Operator's manual
8.3.4 Moving and stopping the machine
Moving the machine
f Press the control levers on the remote control, and hold them in the desired
position.
The machine will start vibrating and move in the desired direction.
The further forward or backward you press the control levers, the faster the
machine will move.
Stopping the machine
f Release both control levers on the remote control.
The machine will stop vibrating and moving.
After approx. 6 seconds, the engine will switch to idling.
8.3.5 Turning on and off slow/fast operation
Note: Fast operation is turned on by default.
Slow operation is only intended for traversing highly compressed
surfaces or hard substructures.
f Press the Slow/fast operation button in order to switch between slow and fast
operation.
The machine is in slow operation when the receiver units flash yellow slowly.
Item Designation
1 Slow/fast operation button
To Next Page
Loading...
Need help?
General
