8 Use and operation DPU 130Le
67
Operator's manual
8.7 Setting transmission channel
The machine can only be operated when the transmission channel of the
machine is the same as that of the remote control.
16 different transmission channels are available; the channel can be set with a
rotary switch on the remote control. When the transmission channel has been set
on the remote control, this must be coordinated with the machine.
It may be necessary to set the transmission channel in the following cases:
Operating multiple remote controlled machines within the receiving area.
If the transmission channel was adjusted on the remote control or the remote
control was replaced with another one.
Removing battery from remote control
f Press the lug while pulling the battery out to the right.
WARNING
Unintentionally controlling multiple machines within the receiving area.
Risk of serious injury due to crushing.
f Set machines to different transmission channels when operating multiple
machines within the receiving area.
Item Designation
1 Battery
2 Lug
To Next Page
Loading...
Need help?
General
