Xerox COLORQUBE 8570 Service Manual

October 2012
2-7
ColorQube 8570/8870 Service Manual
PS NVRAM Reset
Fault Messages and Codes
Xerox Internal Use Only - Revised, 3rd Revision
Table 2 summarizes printer parameters not affected by an NVRAM Reset.
Tray 2-4 Mode Dynamic No Dependent on
number of
installed trays.
Tray 2-5 Mode Dynamic No Dependent on
number of
installed trays.
PostScript Setup PostScript Error Info Off No
Print-Quality Mode Enhanced No
Color-Correction Automatic No
User-Defined Screens Off No
PCL Setup Font Number 0 No
Pitch 10 No
Point Size 12 No
Symbol Set PC-8 No
Orientation Portrait No
Form Length 60 No
Line Termination On No
Enhanced Mode Off No
Color Mode Color No
Wide A4 Off No
Table 2 Parameter Not Affected by a PS NVRAM Reset
Parameter Comment
Metric Defaults Set to Off, default sizes are interpreted in inches.
MAC Address Set by the Configuration Card.
Serial Number
Model Number
License Number
VxWorks Version
PostScript Version
PostScript Revision
Engine Version
Network Version
Activision Date
Print Count
Billing Meters
Substituted Jets
Warm-up Mode Set to Intelligent Ready
Warm-up Settings Set to Job Activated
Table 1 Parameters Reset with Service Diagnostics PS NVRAM Reset Command
Menu Parameter Default Required Comment
Stand-by Settings Set to idle after timeout
Table 2 Parameter Not Affected by a PS NVRAM Reset
Parameter Comment

Xerox COLORQUBE 8570 Specifications

General

Brand	Xerox
Model	COLORQUBE 8570
Category	Printer
Language	English