99
4. Output torque up to limit value signal
Output signal when
motor output torque up
to P3-28, P3-29.
No terminals are assigned by default. The parameter range is 0000-0014, which is assigned to the
output interface through parameter P5-42. When set to 0002, the signal is output from the SO2
terminal.
5.7.3 Speed limit
Forward max speed
command limit
Reverse max speed
command limit
Note: P3-14 and P3-15 are effective in all the modes.
5.7.4 I/O signal distribution
5.7.4.1 Input terminal distribution
1. Input signal distribution
n. 0
Distribute input
terminal no.
0: NO signal
1: NC signal
No meaning
Basic filter time
Not distribute to terminal input
Input always open signal from SIx
Set the signal to be always valid
Input always close signal from SIx
Note: The basic filtering time refers to input terminal filtering time.
2. default setting of input terminal
3. Filtering time of input terminal
Related parameter
SI filtering time
multiple
SI input filtering time is determined by IO parameter value and P5-18. Examples are as follows:
Pulse deviation clear set to SI1 terminal, and 30ms Filtering Time
The parameters are set as follows:
P5-34=n. 0 3 0 1
P5-34.0
P5-34.2
To Next Page
Loading...
Need help?
General
