Xinje DS5F Series User Manual

40
4 Operate panel
4.1 Basic operation
4.1.1 Operating panel description
The panel will be self-checked, and all the display digital tubes and five decimal points will be lit for
one second at the same time.
4.1.2 Button operation
By switching the basic state of the panel operator, it can display the running state, set parameters, run
auxiliary functions and alarm state. After pressing the STA/ESC key, the states are switched in the
order shown in the following figure.
State: BB indicates that the servo system is idle; run indicates that the servo system is running; RST
indicates that the servo system needs to be re-energized.
idle
run
reset
Function parameter
Control parameter
Communication
parameter
Power on times
Jog
Alarm code
Alarm code
Present speed Alarm clear
state Parameter
Monitor
Auxiliary Alarm
STA/ESC switch
 Parametric setting Px-xx: The first X represents the group number, and the last two X
represents the parameter serial number under the group.
 Monitor status Ux-xx: The first X represents the group number, and the last two X represents
the parameter number under the group.
 Auxiliary function Fx-xx: The first X denotes the group number, and the last two X denotes
the parameter number under the group.
 Alarm state E-xxx: The first two X denote the alarm category, and the last x denotes the
small category under the category.
Button
Operation
STA/ESC
Short press: state switch, state return
INC
Short Press: The display data increases
Long press: The display data increases
continuously
DEC
Short Press: The display data decreases
Long press: The display data decreases
continuously
ENTER
Short press: shift;
Long press: Set and view parameters.
STA/ESC
INC
DEC ENTER

Xinje DS5F Series Specifications

General

Brand	Xinje
Model	DS5F Series
Category	Servo Drives
Language	English