Page 114 FTDX9000D OPERATION MANUAL
MEMORY GROUPS
MEMORY GROUP ASSIGNMENT
1. Press the MNU key to enter the Menu mode.
2. Rotate the Main tuining Dial, or use the TFT’s F6
and F7 keys, to select Menu item GENERAL 031
MEM GROUP.
Rotate the CLAR/VFO-B knob, or use the TFT’s
F4]/ F5 keys, to set this Menu item to “ENABLE”
(the default setting is “DISABLE”).
3. Press and hold in the MNU key for two seconds to
seave the new setting and exit. Operation will now be
restricted to the six Memory Groups.
To cancel Memory Group operation, repeat steps (1)
through (3) above, choosing “DISABLE” in step (2).
Advice
Note that for the PMS memory group, the PMS memories
“P1L” through “P9U” will be so designated, so as to avoid
confusion.
CHOOSING THE DESIRED MEMORY GROUP
You may recall memories just within a particular Memory Group, if desired.
1. Press the V/M key (# ), if necessary, to enter the
Memory mode.
2. Press and hold in the MCH/GRP key (# ) (below
and to the left of the CLAR/VFO-B knob) for two
seconds. The imbedded LED inside the switch will
light up.
3. Rotate the CLAR/VFO-B knob to select the desired
Memory Group.
To exit from Memory Group operation, press and hold in
the MCH/GRP key for two seconds once more.
Advice
H You will now be operating using memories only within
the selected Memory Group.
H If no channels have been assigned to a particular
Memory Group, you will not have access to that Group.
Memory Channel Number
Groups Memory “OFF” Groups Memory “ON”
01 ~ 19 1-01 ~ 1-19
20 ~ 39 2-01 ~ 2-20
40 ~ 59 3-01 ~ 3-20
60 ~ 79 4-01 ~ 4-20
80 ~ 99 5-01 ~ 5-20
P-1L/1U ~ P-9L/9U P-1L/1U ~ P-9L/9U
CLAR/VFO-B knob
MNU key
MCH/GRP switch
CLAR/VFO-B knob
V/M key
MCH/GRP switch
To Next Page
Loading...
Need help?
General
