4-REAR WHELL COMPONENT 22
CHK
ADJ
NO. PART NO.
1 1100100-092000
－
S rear disk brake piece (HS10)
1 After-sales
Fig.6 REAR WHELL
COMPONENT
PROCEDURE:
●Disassemble disc brake arrester
Using strait screwdriver to disassemble nut①.
Disassemble pin axle② with a 5# inner hexagon socket.
Disassemble rolling axle③ with socket sleeve.
Take off rear disc brake arrester⑴.
●Change rear disc brake arrester
Put the piston of clamp towards the direction of arrow to the end. See photo left below. To reduce
resistance, you can disassemble the cross bolt on rear disc brake main pump oil cup. Take off the top cover
and sealing gasket. Remember to rebound the pister afterwards.
The new arrester must fit tightly the slot. See photo right below.
Tighten the pin axle② with 5# inner hexagon socket tool.
Tighten rolling axle③ with socket sleeve.
Tighten nut① with strait screwdriver.
Step on braking pedal several times until braking force is recovered.
CAUTION:
●Check regularly the arrester and disc brake plate status.
●To change arresters in qualified mainenance spot are suggested.
●After changing the arrester, adjust the height of braking pedal according to "Foot pedal, gear shift rod
assembly" if necessary.
●It needs running-in for about 300km after changing new arresters. During this period, leave enough braking
distance while riging.
Replace the rear brake pads
To Next Page
Loading...
Need help?
General
