5-PEDAL COMPONENT 25
CHK
ADJ
NO. PART NO.
2 1250205-023000 GB70.1 inner hexagonal M8×35 (color Zinc) 2
3 1250104-006097 GB16674M6×12 (chromed/HH) 1
4 1186500-009000 KD20-C rear brake switch 1
5 1100101-025000 KD20-C rear brake switch spring (A) 1
6 1100101-022000 KD200-C brake switch rotation bracket 1
7 1100101-024000 KD20-C rear brake switch bracket 1
10 1100101-026000 KD20-C rear brake switch spring (B) 1
●Right Foot pedal component
Loosen the main pump nut as described on the previous page for adjusting the brake pedal.
In order to facilitate the operation, here we will explain the method of removing the pedal bracket, or you
can follow the steps in the manual but it will be more difficult because the operating space is narrower.
Remove the waterproof rubber plug⑴, and remove the two bolts⑵ with a 6# hexagonal socket. Grasp the
rear brake switch bracket and remove the bolt⑶ with an 8# socket.
Flip the footrest bracket assembly over to the back. Remove the rear brake switch spring⑸ from the switch
⑷.
Remove the circlip, pads and pin that came with the rear brake main pump.
Remove the rotation bracket⑹ and pad⑼ after removing the bolt⑻ with a 14# socket.
Install the complimentary extension after removing the U-joint and screw it onto the main pump adjusting
screw without locking the nut first.
After moving the right foot pedal assembly with the brake pedal forward one hole, put back the bolt⑻ and
the rotation bracke⑹ and pad⑼. Note that the rotation bracket needs to snap into the groove of the brake
pedal and the bolt⑻ needs to be coated with thread tightening glue.
Put back the circlip, pad and pin that come with the rear brake main pump.
Replace the brake switch spring with an extended spring⑽ and put it back on the brake switch. Install the
bracket⑺ back onto the footrest bracket with the bolt⑶. Install the pedal bracket assembly back onto the
frame and plug the rubber plug.
Fig.2 FOOT PEDAL
COMPONENT
1
with the vehicle
gift
2
1
1
GB5789 M10×1.25×25 (10.9 grade environmental
protection color)
Non-standard flat pad φ10.2×φ17×2.8
(environmental color)
ZT310-V rear brake main pump piston push rod
extension rod
Front right pedal mounting position adjustment
ZT310 Univsersal side box bracket waterproof rubber
plug
1244200-052000
1250105-278093
1276500-027000
1274200-170000
1
8
9
Adjust the brake pedal as described on the previous page, and lock the nut that comes with the main
pump when it is properly adjusted.
11
To Next Page
Loading...
Need help?
General
