ABB ACS800-67 - Creating a Full Backup Package and Saving It in.BPG Format

96 Practical examples
Creating a full Backup Package and saving it in .BPG
format
While creating a Backup Package, the converter must be in remote control (not controlled
from the DriveWindow).
Make a Backup Package with DriveWindow separately from each converter as follows:
1. Open a new backup folder by selecting from the File menu System Software / New /
Backup Package.
2. Select from the File menu System Software / Backup command.
3. Select the appropriate converter and press Backup.
4. The backing up takes a few minutes.
5. Select from the File menu System Software / Save as command. Select a folder
where you will save the Backup Package.
6. Give a file name to your Backup Package and press Save.
7. Close your folder by selecting from the File menu System Software / Close
command.
Converters with one rotor-side converter and one
grid-side converter