Fault tracing 405
Fault tracing
Contents of this chapter
The chapter lists the warning and fault messages including possible causes and
corrective actions. The causes of most warnings and faults can be identified and
corrected using the information in this chapter. If not, an ABB service representative
should be contacted.
Warnings and faults are listed below in separate tables. Each table is sorted by
warning/fault code.
Safety
WARNING! Only qualified electricians are allowed to service the drive. Read
the Safety instructions on the first pages of the Hardware manual before
working on the drive.
Indications
Warnings and faults indicate an abnormal drive status. The codes and names of
active warnings/faults are displayed on the control panel of the drive as well as the
Drive composer PC tool. Only the codes of warnings/faults are available over
fieldbus.
In addition to warnings and faults, there are pure events that are only recorded in the
event log of the drive. The codes of these events are included in the Warning
messages table.
For some warnings and faults, the message text are edited and instructions and
contact information added. To edit these messages, choose Settings - Edit texts on
the control panel.
To Next Page
Loading...
