ABB ACS880 PCP User Manual

Parameters 353
98.12 SigmaL user SI Defines the leakage inductance σL
S
.
Note: This parameter is valid only for asynchronous
motors.
0.00 mH
0.00…100000.01 mH Leakage inductance. 1 = 10000 mH
98.13 Ld user SI Defines the direct axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet
motors.
0.00 mH
0.00…100000.01 mH Direct axis inductance. 1 = 10000 mH
98.14 Lq user SI Defines the quadrature axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet
motors.
0.00 mH
0.00…100000.01 mH Quadrature axis inductance. 1 = 10000 mH
98.15 Position offset user Defines an angle offset between the zero position of the
synchronous motor and the zero position of the position
sensor.
This value is initially set by the autophasing routine when
parameter 21.13 Autophasing mode is set to Turning with
Z-pulse, and can be fine-tuned later on.
Notes:
• The value is in electrical degrees. The electrical angle
equals the mechanical angle multiplied by the number
of motor pole pairs.
• This parameter is valid only for permanent magnet
motors.
0 deg
0…360 deg Angle offset. 1 = 1 deg
99
99 Motor data
Motor configuration settings.
99.03 Motor type Selects the motor type.
Note: This parameter cannot be changed while the drive is
running.
Asynchronous
motor
Asynchronous motor Standard squirrel cage AC induction motor (asynchronous
induction motor).
0
Permanent magnet
motor
Permanent magnet motor. Three-phase AC synchronous
motor with permanent magnet rotor and sinusoidal
BackEMF voltage.
1
SynRM (Only visible with option +N7502)
Synchronous reluctance motor. Three-phase AC
synchronous motor with salient pole rotor without
permanent magnets.
2
No. Name/Value Description Def/
FbEq16

ABB ACS880 PCP Specifications

General

Brand	ABB
Model	ACS880 PCP
Category	DC Drives
Language	English