IV U1253B User’s and Service Guide
General Safety Information
The following general safety precautions must be observed during all
phases of operation, service, and repair of this instrument. Failure to
comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture, and intended
use of the instrument. Agilent Technologies assumes no liability for the
customer’s failure to comply with these requirements.
• Turn off the circuit power and discharge all high-voltage capacitors in the circuit before
you perform resistance and capacitance measurements or continuity and diodes tests.
• Use the correct terminals, function, and range for your measurements.
• Never measure voltage when current measurement is selected.
• Use only the recommended rechargeable battery. Ensure proper insertion of battery in
the multimeter, and follow the correct polarity.
• Disconnect test leads from all the terminals during battery charging.
To Next Page
Loading...
Need help?
General
