3 Using the Scope Functions
82 Agilent U1602B/U1604B User’s and Service Guide
Figure 3-41 The <Load> display indicates that a configuration setup file has been saved
into Setup 1 and you can press F1 to retrieve the setup from internal memory.
To Save and Recall Waveform
To save or recall waveforms from internal memory, follow the instructions
below:
1 Press and hold to access Save/Recall menu.
2 Press F2 to access Save/Load Waveform menu.
3 Up to 10 waveforms can be stored over four pages of menu. Press the
respective softkey to save or load waveform to/from internal memory.
4 In Figure 3- 41, press F1 to save the configuration setup into Setup 1.
5 Press F1 again to load the Waveform 1 from the internal memory. Refer
to Figure 3- 42.
6 Go through the same save and recall waveform steps for saving and
recalling the subsequent waveforms.
To Next Page
Loading...
Need help?
General
