Chapter 3: Configuration and commissioning
102 2X Series Installation Manual
Secure access
Select the Secure access option to configure the control panel to allow secure or
nonsecure access. The default setting is for secure access (all username and
password information must be entered at each login).
• If nonsecure access is selected, the control panel automatically prefills the
last username and password combination entered for login
• If secure access is selected, all username and password information must be
entered at each login
To configure the security setting:
1. Select Password setup from the Main menu, and then select Secure access.
2. Select the required security setting.
3. Press F4 (Enter), and then press F1 (Back).
4. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Commissioning
After the control panel and corresponding devices are installed and configured,
the system must be commissioned.
Check the following:
• That the fire system is designed in accordance with all required regulations
and standards
• That the maximum alarm current in your installation does not exceed the
maximum current specifications of the power supply
• That all equipment is correctly installed and tested and that all cabling
complies with the recommendations outlined in “Recommended cables” on
page 24
• That all software functions are correctly programmed
• That all installed detectors are appropriate for installation environment and
operate correctly
• That all inputs and outputs operate correctly
• That any input/output logic (rules and actions) configuration is correct
• That the fire system is functioning correctly in standby and is not reporting
any alarms or faults
To Next Page
Loading...
Need help?
General
