Aritech 2X Series User Manual

Chapter 3: Configuration and commissioning
2X Series Installation Manual 73
GPRS configuration
Select the GPRS configuration option to configure general packet radio service
(GPRS) settings. Configuration options are shown in the table below.
Note: GPRS functionality requires an optional GPRS expansion board to be
installed.
Table 34: GPRS configuration options
Option
Description Default value
PIN
Configures the sim card PIN number 0000
APN
Configures the network Access Point Name (APN)
User
Configures the network user name
Description
Configures the description
Password
Configures the network password
Period
Configures the heartbeat period (in seconds) 60 s
Fails
Configures the minimum number of consecutive
heartbeat failures required to indicate a
communication error with the central monitoring
station
03
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select Other settings, and then select DACT config.
3. Select GPRS config.
4. Configure all required settings.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Field configuration
Use the Field setup menu to access the field configuration options shown below.
Table 35: Field configuration options
Option
Description
Autosetup
Automatically configures installed loop devices to their default
settings.
Loop device configuration
Configures installed loop devices or change default settings.
Zone configuration
Configures zones.
Panel I/O configuration
Configures control panel input and output functionality.
Output groups
Configures output groups.

Aritech 2X Series Specifications

General

Brand	Aritech
Model	2X Series
Category	Fire Alarms
Language	English