Aritech 2X Series User Manual

Chapter 3: Configuration and commissioning
2X Series Installation Manual 69
Option
Description
Cond
[2] Configures the printing of condition events
StatCH
[2] Configures the printing of status change events (for example, inputs
and outputs)
[1] This option is not available for internal printers.
[2] When RportMd is checked, these system events are not printed.
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select Other settings, and then select Printer config.
3. Select Int printer config or Ext printer config.
4. Select and check the check box for the options that you want to enable.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
DACT configuration
Select the DACT configuration option to configure settings for an installed DACT
expansion board. Configuration options are shown in the table below.
Table 29: DACT configuration options
Option
Description
General config
Configures the DACT status (used or not used) and event reporting
options
Ethernet config
Configures Ethernet settings for monitoring network communication
with the central monitoring station (CMS)
CMS config
Configures CMS settings
PSTN config
Configures PSTN settings
GPRS config [1]
Configures GPRS settings
[1] Requires an optional GPRS expansion board to be installed.

Aritech 2X Series Specifications

General

Brand	Aritech
Model	2X Series
Category	Fire Alarms
Language	English