10. Removal and installation of projector covers
C
A
B
Image 10-4
Remove input cover
10.3 Removal of the front cover
The input co ver an d the lens have to be remo ved before remo ving t he front cover. See procedures "Rem oval
of the input cover", page 68, and "Lens remo val", page 39.
Necessary tools
Flat screw driver
How to remove the front cover of the projector
1. Check if the input cover an d the lens are rem oved.
2. Remove the rubber dust ring from the lens holder. See the detail a t the right side of image 10-5.
3. Release the captive screw at the middle bottom of the front c over, us ing a flat screw drive r.
Image 10-5
Release front cover
4. Remove the front cover from the projector doing the following:
a) standing in front of the projector, pull the u
pper right co rner (A) of the front cover toward you until the latch releases,
b) pull the lower right corner (B) of the front cover toward you until the latch r eleases,
c) then move the front cover away from the projector.
R5905050 DP2K C-SERIES 10/07/2012
69
To Next Page
Loading...
Need help?
General