41
7217395.01 - en
INSTRUCTIONS PERTAINING TO THE INSTALLER
•
Press the +/- domestic hot water buttons to display the following instantaneous information:
A00: domestic hot water temperature value (°C);
A01: outside temperature (with external probe sensor connected);
A02: modulatine current value (100% = 230 mA METANE - 100% = 310 mA GPL);
A03: power range level value (%) - see parameter F13 (section 19);
A04: temperature setpoint value (°C);
A05: central heating ow temperature value (°C);
A06: ow water value (l/min x 10);
A07: ame signal value (8-100%).
Note: lines A08 and A09 are not used.
•
This function is active for 3 minutes. To exit the function, press button as described in section 3.2.
Note: the resetting operation is available only for 5 consecutive attempts, after which the RESET function is disabled and
the gas boiler remains blocked.
To carry out a new RESET attempt, proceed as follows:
• press the
button for at least 2 seconds;
• reset the boiler pressing the
button for at least 2 seconds, the display shows “OFF”;
.
• press the
button for at least 2 seconds as describe in section 3.2.
See section 9 for error codes and anomalies description.
18.3 ANOMALIES DISPLAY
For more detailed technical information, please consult the “SERVICE INSTRUCTIONS”.
18.4 ADDITIONAL INFORMATION
To Next Page
Loading...
Need help?
General