AUTO DIAL NUMBERS AND DIALING OPTIONS
7 - 4
BHL-FB-MFC-5100C-FM5.5
Dialing Options
Search
You can search for names you have stored in Speed Dial memory. (See Storing
Speed Dial Numbers
, page 7-1.)
1
Place the original face up in the ADF, or face down on the scanner glass.
2
Press Search/Speed Dial.
3
To search for numbers alphabetically by name, enter the first letter of the name,
and then press
or .
—OR—
To search for numbers numerically by Speed-Dial number, press .
4
When the LCD shows the name you want to call, press Black Fax Start.
Speed Dialing
1
Place the original face up in the ADF, or face down on the scanner glass.
2
Press Search/Speed Dial, press #, then press the two-digit Speed Dial
location. (See
Storing Speed Dial Numbers, page 7-1.)
3
Press Black Fax Start.
Access Codes and Credit Card Numbers
Sometimes you may want to choose from among several long distance carriers
when you make a call. Rates may vary depending upon the time and destination.
To take advantage of low rates, you can store the access codes or long-distance
carriers as Speed-Dial numbers. You can store these long dialing sequences by
dividing them and setting them up on separate keys in any combination. You can
even include manual dialing using the dial pad. The combined number will be
dialed in the order you entered it, as soon as you press Black Fax Start.
(See
Storing Speed Dial Numbers, page 7-1.)
You can store “555” on Speed Dial #03 and “7000” on Speed Dial #02. If you
press Search/Speed Dial, #, 0, 3, Search/Speed Dial, #, 0, 2, and Black
Fax Start, you can dial “555-7000”. To temporarily change a number, you can
substitute part of the number with manual dialing using the dial pad. For
example, to change the number to 555-7001 you could press Search/Speed
Dial, #, 03 and then press 7, 0, 0, 1 using the dialing pad.
When you dial using an auto dial number, the LCD shows the name you’ve
stored, or if you haven’t stored a name, the fax number you’ve stored.
Note
If you must wait for another dial tone at any point in the dialing sequence, store
a pause at that point in the number by pressing Redial/Pause. Each key press
adds a 3.5 second delay.
or
To Next Page
Loading...
Need help?
General
