Chapter 7
34
Using a scanned paper document as
your watermark
7
a Press (COPY).
b Enter the number of copies you want.
c Press a or b to choose
Watermark Copy.
Press OK.
d Press d or c to choose On.
e Press a or b to choose
Current Setting.
Press OK.
f Press a or b to choose Scan. Press OK,
and place the page that you want to use
as a watermark on the scanner glass.
g Press Mono Start or Colour Start.
h Take out the watermark document you
scanned and load the document you
want to copy.
i Press d or c to change the
Transparency of the watermark.
Press OK.
j If you do not want to change any
additional settings, press Mono Start or
Colour Start.
You cannot enlarge or reduce the
scanned watermark.
Setting your changes as a
new default 7
You can save the copy settings for Quality,
Enlarge/Reduce, Density,
Ink Save Mode and Page Layout that
you use most often by setting them as the
default settings. These settings will stay until
you change them again.
a Press (COPY).
b Press a or b and d or c to choose your
new setting.
Press OK.
Repeat this step for each setting you
want to change.
c After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d Press 1 to choose Yes.
e Press Stop/Exit.
Restoring all settings to the
factory settings
7
You can restore the copy settings
Quality, Enlarge/Reduce, Density,
Ink Save Mode, and Page Layout, that
you have changed, to the factory settings.
a Press (COPY).
b Press a or b to choose
Factory Reset.
Press OK.
c Press 1 to choose Yes.
d Press Stop/Exit.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
