20
Inserting the Remote Control Batteries
■ Make sure the battery is installed with the correct polarity.
■ Do not use the old and new batteries or the batteries of different types together.
■ Remove the battery if the remote control may not be used for a long time to prevent the damage
caused by leaks.
1. Slide the battery cover as illustrated.
2. Place two AA batteries in the compartment, make sure
the polarity in the compartment and batteries are aligned
correctly.
3. Slide the battery cover back.
Installing the Lens
1. Remove the dust cap.
2. Remove the new lens from its packaging.
3. Remove the lens covers from the rear and front of the
new lens. Remove them before continuing.
Setup and Operation
To Next Page
Loading...
Need help?
General
