Advanced Guide
Troubleshooting
Contents
> Safety Precautions
Safety Precautions
Please read the safety warnings and cautions provided in this manual to ensure that you use the printer
safely. Do not attempt to use the printer in any way not described in this manual. It causes unexpected
accident, fire, or electric shock.
Note
The power supply is AC100-240V 50/60Hz via AC power supply unit K30309.
Warning
The following are instructions that, if ignored, could result in death or serious personal injury
caused by incorrect operation of the equipment. These must be observed for safe operation.
Choosing a
location
Do not place the printer close to flammable solvents such as
alcohol or thinners.
Power
supply
Never attempt to plug in or unplug the printer from the power
supply when your hands are wet.
Always push the plug all the way into the power outlet.
Never damage, modify, stretch or
excessively bend or twist the power
cord.
Do not place heavy objects on
the power cord.
Never plug the printer into a power
socket that is shared with other
equipment (extension lead/cord, 2- or
3-way adapter, etc.).
Never use the printer if the power cord is bundled or knotted.
If you detect smoke, unusual smells or strange noises around
the printer, immediately unplug the printer at the power supply
and call for service.
Periodically, unplug the printer and
use a dry cloth to wipe off any dust or
dirt collected on the plug and the
power outlet.If the printer is placed at
a location exposed to a lot of dust,
smoke, or high humidity, the dust
collected on the plug absorbs
moisture and may cause insulation
failure and fire.
If you hear thunder, disconnect the power supply of the printer
and refrain from using it.
Leaving the printer plugged in may
cause fire, electric shock, or damage to the printer, depending
on the thunder storm.
Use the power cable included with the printer.
Cleaning the
printer
Use a damp cloth to clean the printer.
Never use flammable solvents such
as alcohol, benzene or thinners.
If flammable solvents come in contact with
electrical components inside the printer, it
could cause a fire or electric shock.
Page 3 of 541 pagesSafety Precautions
To Next Page
Loading...
Need help?
General
