Alarm
The watch performs a beep or vibration alert
operation when an alarm time is reached. You
can set up to four different alarms. The hourly
time signal causes the watch to beep every
hour on the hour.
●
You can enable the beep and vibration
alerts as required.
l
Configuring Sound and Vibration
Settings
●
The watch does not perform a vibration alert
while the battery level indicator shows
. The watch does not perform a beep
alert while the battery level indicator is
“CHG” or lower.
●
While the snooze function is turned on, the
alert operation is performed up to seven
times every five minutes.
●
For information about a smart alarm that
detects your sleep status and alerts you
when your sleep is light, see the information
below.
l
Smart Alarm
Configuring Alarm Settings
Use the CASIO WATCHES phone app or
watch operations to configure alarm settings.
●
To configure alarm settings with the
CASIO WATCHES phone app
Check the connection
●
Make sure the
e
symbol is shown on the
watch display when you perform the
procedure below. If
e
is not displayed,
refer to the information at the link below.
l
Connecting with a Phone Paired
With the Watch
1.
Y
Tap the “CASIO WATCHES” icon.
2.
Y
Tap the “My Watch” tab.
3.
Y
Select “GPR-H1000” and tap it.
4.
Y
Select the setting you want to change
and then perform the operation shown on
the screen.
●
To configure alarm settings with the
watch
1. Display the current time screen.
l
Watch Mode
2. Hold down (A) for at least two seconds.
This enters the Control Mode.
3. Use (A) and (D) to select [SETTING].
4. Press (C).
This displays the setting menu screen.
5. Use (A) and (D) to move the pointer to
[WATCH SETTINGS].
6. Press (C).
This displays the watch setting screen.
7. Use (A) and (D) to move the pointer to
[ALARM].
8. Press (C).
9. Use (A) and (D) to move the pointer to the
alarm you want to set.
10. Press (C).
11. Use (A) and (D) to select an alarm and
snooze function ON/OFF setting.
[OFF]
Disables alarm, disables
snooze
[ON]
Enables alarm, disables
snooze
[ON (SNZ)]
Enables alarm, enables
snooze
●
The currently selected setting is
indicated by a check mark ( ) to the
left.
12. Press (C).
Watch Operation Guide 3554
60