Casio 3554 User Manual

8. Use (A) and (D) to select the pool length
you want.
[25m] 25 meters
[50m] 50 meters
[25yd] 25 yards
[50yd] 50 yards
9. Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the pool swimming setting
screen re-appears.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Enabling Auto Pause
While Auto Pause is enabled, timing will pause
whenever you stop running.
Note
●
When a measurement operation is
restarted from auto pause, the watch
display will be delayed from the actual
start, but the time and distance being
measured are not affected.
●
For RUNNING and WALKING, Auto
Pause becomes difficult to work while
the GPS reception interval is [OFF] or
if the GPS signal is lost.
●
For BIKING, Auto Pause does not work
while the GPS reception interval is set
to [LONG] or [OFF], or if the GPS signal
is lost.
l
Changing the GPS Receive
Interval
●
If auto pause does not work after it is
enabled or if measurement does not
resume, pause and resume
measurement manually.
1. Display the current time screen.
l
Watch Mode
2. Press (C).
This enters the Activity Mode.
Example:
3. Use (A) and (D) to select an activity.
4. Press (C).
●
For activities that can be measured
without receiving GPS signals, this
operation returns to the measurement
operation ready screen. In this case,
advance to step 6.
●
If you selected an activity that receives
GPS signals for measurement, this
operation starts the GPS signal receive
operation.
5. If you selected an activity that receives
GPS signals for measurement, press (A)
or (D).
This displays the measurement operation
ready screen.
6. Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7. Use (A) and (D) to move the pointer to
[AUTO PAUSE].
8. Press (C).
9. Use (A) and (D) to move the pointer to
[ON] (enabled) or [OFF] (disabled).
10. Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the activity measurement setting
screen re-appears.
11. Press (E) to exit the setting screen.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
You can also use the CASIO
WATCHES phone app to enable or
disable Auto Pause.
Watch Operation Guide 3554
70

Casio 3554 Specifications

General

Brand	Casio
Model	3554
Category	Watch
Language	English