Casio 3554 User Manual

Alert Screen Switching
A training alert screen appears when a
specified target value is reached during
activity measurement.
Example:
●
The watch returns to the running
measurement screen if you press (C) or if
you do not perform any operation for about
nine seconds.
Configuring Distance
Measurement Settings
You can select measurement of either linear
distance (straight-line distance) or surface
distance (actual distance).
Surface distance measurements are
calculated by taking horizontal travel as well
as vertical movement into consideration.
1. Display the current time screen.
l
Watch Mode
2. Press (C).
This enters the Activity Mode.
Example:
3. Use (A) and (D) to select an activity.
4. Press (C).
This displays the GPS signal receive start
screen.
5. Press (A) or (D).
This displays the measurement operation
ready screen.
6. Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7. Use (A) and (D) to move the pointer to
[GPS TRACKING].
8. Press (C).
9. Use (A) and (D) to move the pointer to [3D
DISTANCE].
10. Press (C).
11. Use (A) and (D) to select a setting.
[ON] Surface distance measurement
[OFF] Linear distance measurement
12. Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the GPS setting screen re-
appears.
13. Press (E) to exit the setting screen.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
You can also use the CASIO
WATCHES phone app to change the
distance measurement type.
Configuring Interval Timer
Settings
●
To configure interval timer settings with
the CASIO WATCHES phone app
You can use the CASIO WATCHES phone
app to configure an interval timer that
combines multiple types of timers.
●
For information about interval timers, see
the information below.
l
Overview
Check the connection
●
Make sure the
e
symbol is shown on the
watch display when you perform the
procedure below. If
e
is not displayed,
refer to the information at the link below.
l
Connecting with a Phone Paired
With the Watch
1.
Y
Tap the “CASIO WATCHES” icon.
2.
Y
Tap the “My Watch” tab.
3.
Y
Select “GPR-H1000” and tap it.
4.
Y
Select the setting you want to change
and then perform the operation shown on
the screen.
Watch Operation Guide 3554
73

Casio 3554 Specifications

General

Brand	Casio
Model	3554
Category	Watch
Language	English