13. Use (A) and (D) to set the alarm hour.
14. Press (C).
15. Use (A) and (D) to set the alarm minute.
16. Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the alarm selection screen re-
appears.
●
You can view the setting time of the
alarm and whether the alarm setting and
snooze setting are on or off.
17. Hold down (E) for at least one second to
return to the current time screen.
Note
●
If you want to exit the alarm setting
operation at any time, press (E) several
times to return to the watch setting
screen.
●
To stop a sounding alarm
While an alarm sound and/or vibration
operation is being performed, press any
button to stop it.
Note
●
The watch performs a 10-second
sound/vibration operation when a
preset alarm time is reached.
●
When snooze is enabled for an alarm,
alarm sound and/or vibration will
repeat every five minutes, up to seven
times. To stop an alarm’s ongoing
snooze operation, turn off the alarm.
●
If you do not perform any operation for
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the current
time screen.
Enabling the Hourly Time
Signal
Use the CASIO WATCHES phone app to turn
the hourly time signal on or off.
Important!
●
You cannot change the hourly time
signal setting using a watch operation.
Use the CASIO WATCHES phone app
to change the setting.
Check the connection
●
Make sure the
e
symbol is shown on the
watch display when you perform the
procedure below. If
e
is not displayed,
refer to the information at the link below.
l
Connecting with a Phone Paired
With the Watch
1.
Y
Tap the “CASIO WATCHES” icon.
2.
Y
Tap the “My Watch” tab.
3.
Y
Select “GPR-H1000” and tap it.
4.
Y
Select the setting you want to change
and then perform the operation shown on
the screen.
Note
●
The hourly time signal is disabled
during the period you have set as
NIGHT TIME.
Turning Off an Alarm
To stop an alarm sound and/or vibration
operation, perform the steps below to turn it
off.
●
To reactivate an alarm sound and/or
vibration operation, turn it back on.
Note
●
An indicators is displayed while any
one of the alarms is turned on.
●
The alarm indicator is not displayed
while all of the alarms are turned off.
1. Display the current time screen.
l
Watch Mode
2. Hold down (A) for at least two seconds.
This enters the Control Mode.
3. Use (A) and (D) to select [SETTING].
4. Press (C).
This displays the setting menu screen.
5. Use (A) and (D) to move the pointer to
[WATCH SETTINGS].
6. Press (C).
This displays the watch setting screen.
Watch Operation Guide 3554
61
To Next Page
Loading...
Need help?
General
