Chapter 4 Setting Up and Managing Network Configuration
AAA Server Configuration
4-20
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Step 2 Do one of the following:
• If you are using NDGs, click the name of the NDG to which the AAA client
is assigned. Then, click the AAA client hostname in the AAA Clients table.
• To delete a AAA client when you have not enabled NDGs, click the AAA
client hostname in the AAA Clients table.
Result: The AAA Client Setup for the Name page appears.
Step 3 To delete the AAA client and have the deletion take effect immediately, click
Delete + Restart.
Note Restarting Cisco Secure ACS services clears the Logged-in User report
and temporarily interrupts all Cisco Secure ACS services. As an
alternative to restarting when you delete a AAA client, you can click
Delete. However, when you do this, the change does not take effect until
you restart the system. To restart the system, click System
Configuration, click Service Control, and then click Restart.
Result: A confirmation dialog box appears.
Step 4 Click OK.
Result: Cisco Secure ACS restarts AAA services and the AAA client is deleted.
AAA Server Configuration
This section presents procedures for configuring AAA servers in the
Cisco Secure ACS HTML interface. For additional information about AAA
servers, see AAA Servers in Distributed Systems, page 4-3.
To configure distributed system features for a given Cisco Secure ACS server, you
must first define the other AAA server(s).
Tip If the AAA Servers table does not appear, click Interface Configuration, click
Advanced Options, and then select the Distributed System Settings check box.
To Next Page
Loading...
Need help?
General