6-49
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Configuring BBSM RADIUS Settings for a User Group
BBSM RADIUS represents only the BBSM RADIUS VSA. You must configure
both the IETF RADIUS and BBSM RADIUS attributes.
Note To hide or display BBSM RADIUS attributes, see Setting Protocol Configuration
Options for Non-IETF RADIUS Attributes, page 3-16. A VSA applied as an
authorization to a particular group persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the group configuration interface.
To configure and enable BBSM RADIUS attributes to be applied as an
authorization for each user in the current group, follow these steps:
Step 1 Confirm that your IETF RADIUS attributes are configured properly.
For more information about setting IETF RADIUS attributes, see Configuring
IETF RADIUS Settings for a User Group, page 6-37.
Step 2 In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
Step 3 From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 4 From the Jump To list at the top of the page, choose RADIUS (BBSM).
To Next Page
Loading...
Need help?
General