7-49
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 7 Setting Up and Managing User Accounts
Advanced User Authentication Settings
Step 2 Before configuring Nortel RADIUS attributes, be sure your IETF RADIUS
attributes are configured properly. For more information about setting IETF
RADIUS attributes, see Setting IETF RADIUS Parameters for a User, page 7-38.
Step 3 In the Nortel RADIUS Attributes table, to specify the attributes that should be
authorized for the user, follow these steps:
a. Select the check box next to the particular attribute.
b. Further define the authorization for that attribute in the box next to it.
c. Continue to select and define attributes, as applicable.
For more information about attributes, see Appendix C, “RADIUS
Attributes,” or your AAA client documentation.
Step 4 Do one of the following:
• If you are finished configuring the user account options, click Submit to
record the options.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
Setting Juniper RADIUS Parameters for a User
The Juniper RADIUS parameters appear only if all the following are true:
• A AAA client has been configured to use RADIUS (Juniper) in Network
Configuration.
• The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.
• User-level RADIUS (Juniper) attributes you want to apply have been enabled
under RADIUS (Juniper) in the Interface Configuration section.
Juniper RADIUS represents only the Juniper proprietary attributes. You must
configure both the IETF RADIUS and Juniper RADIUS attributes. Proprietary
attributes override IETF attributes.
To Next Page
Loading...
Need help?
General