8-43
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 8 Establishing Cisco Secure ACS System Configuration
RDBMS Synchronization
Performing RDBMS Synchronization Immediately
You can manually start an RDBMS synchronization event.
To perform manual RDBMS synchronization, follow these steps:
Step 1 In the navigation bar, click System Configuration.
Step 2 Click RDBMS Synchronization.
Note If this feature does not appear, click Interface Configuration, click
Advanced Options, and then select the RDBMS Synchronization check
box.
Result: The RDBMS Synchronization Setup page appears.
Step 3 To specify options in the RDBMS Setup table, follow these steps:
Note For more information about RDBMS setup, see RDBMS Setup Options,
page 8-41.
a. From the Data Source list, select the system DSN you configured to
communicate with the database that contains your accountActions table.
For more information about configuring a system DSN for use with RDBMS
Synchronization, see Configuring a System Data Source Name for RDBMS
Synchronization, page 8-40.
b. In the Username box, type the username for a database user account that has
read/write access to the accountActions table.
c. In the Password box, type the password for the username specified in the
Step b.
Result: Cisco Secure ACS has the information necessary to access the
accountActions table.
Note You do not have to select Manually under Replication Scheduling. For
more information, see Disabling Scheduled RDBMS Synchronizations,
page 8-46.
To Next Page
Loading...
Need help?
General