F-5
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Appendix F RDBMS Synchronization Import Definitions
Action Codes
If an action can be applied to either a user or group, “UN|GN” appears, using the
vertical bar to indicate that either one of the two fields is required. To make the
action affect only the user, leave the group name empty; to make the action affect
only the group, leave the user name empty.
This section contains the following topics about action codes:
• Action Codes for Setting and Deleting Values, page F-5
• Action Codes for Creating and Modifying User Accounts, page F-7
• Action Codes for Initializing and Modifying Access Filters, page F-15
• Action Codes for Modifying TACACS+ and RADIUS Group and User
Settings, page F-19
• Action Codes for Modifying Network Configuration, page F-25
Action Codes for Setting and Deleting Values
The two most fundamental action codes are SET_VALUE (action code: 1) and
DELETE_VALUE (action code: 2), described in Table F-2.
The SET_VALUE (action code: 1) and DELETE_VALUE (action code: 2)
actions, described in Table F-2, instruct RDBMS Synchronization to assign a
value to various internal attributes in Cisco Secure ACS. Unless asked to use
these action codes for other purposes by a Cisco representative, you can only use
these action codes for assigning values to user-defined fields (see User-Specific
Attributes, page F-33).
To Next Page
Loading...
Need help?
General