Chapter 5 Setting Up and Managing Shared Profile Components
Command Authorization Sets
5-18
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Note Enter only the command portion of the command/argument string
here. Arguments are added only after the command is listed. For
example, with the command/argument string “show run” you would
type only the command show.
c. Click Add Command.
Result: The typed command is added to the command list box.
d. To add an argument to a command, in the command list box, select the
command and then type the argument in the box to the right of the command.
Note The correct format for arguments is <permit | deny> <argument>. For
example, with the command show already listed, you might enter
permit run as the argument.
Tip You can list several arguments for a single command by pressing Enter
between arguments.
e. To allow arguments, which you have not listed, to be effective with this
command, select the Permit Unmatched Args check box.
f. To add other commands to this command authorization set, repeat Step a
through Step e.
Step 8 When you finish creating the command authorization set, click Submit.
Result: Cisco Secure ACS displays the name and description of the new command
authorization set in the applicable Command Authorization Sets table.
To Next Page
Loading...
Need help?
General