Cisco ASR 5000 Series Installation Guide

Applying Power and Verifying the Installation
▀ Verifying the Installation
▄ ASR 5000 Installation Guide
162
SMC Standby LED States
The Standby LED on the SMC indicates that software is loaded on the card and it is serving as a redundant component.
For the SMC installed in slot 9, this LED is illuminated steady green during normal operation. For the SMC installed in
slot 8, this LED is off during normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 52. SMC Standby LED States
Color
Description
Troubleshooting
Green
Card is in redundant mode
None needed for the SMC in slot 9. If green for the SMC in slot 8,
then verify it is installed properly according to the instructions in this
document.
Blinking
Green
Tasks or processes are being migrated from
the active SMC to the redundant/secondary
SMC
Verify that the Active LED on the redundant SMC is also blinking
green. If so, there is an issue with the active SMC.
None
Card is not receiving power
OR
Card in Active Mode
Verify that the Run/Fail LED is green. If so, the card is receiving
power and POST test results are positive. If it is off, refer to SMC
Run-Fail LED States for troubleshooting information.
Check the state of the Active LED. If it is green, the card is in active
mode.
SMC Status LED States
The Status LEDs on the SMC indicate the status of system level hardware, such as installed cards, fans, and PFUs. This
LED is illuminated steady green during normal operation.
If the LED is not green, use the troubleshooting information also provided to diagnose the problem.
Table 53. SMC Status LED States
Color
Description
Troubleshooting
Green
No system errors detected
None needed.
Red
Failures Detected
Check the Run/Fail LEDs for all installed application cards, and line cards. If any are
red or off, refer to the troubleshooting information in this chapter pertaining to that
device.
None
Card is not receiving power
Verify that the Run/Fail LED is green. If so, the card is receiving power and POST test
results are positive. If it is off, refer to SMC Run-Fail LED States for troubleshooting
information.

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English