Applying Power and Verifying the Installation
Verifying the Installation â–€
ASR 5000 Installation Guide â–„
Table 71. Optical (ATM) Line Card Standby LED States
Card is in Redundant mode
None needed for line cards installed in slots 33 through 39 and 42 through 48 after
configuration.
If green for line cards installed in slots 17 through 23 and 26 through 32, refer to the
System Administration Guide for troubleshooting information.
Card is in Ready Mode
OR
Card is not receiving power
OR
Card is in Active Mode
This is normal prior to configuration. Neither the Active nor Standby LEDs on the card
will be on.
Verify that the Run/Fail LED is green. If so, the card is receiving power and POST test
results are positive. If it is off, refer to Optical (ATM) Line Card Run-Fail LED States
for troubleshooting information.
Check the state of the Active LED. If it is green, the card is in standby mode. Refer to
the System Administration Guide for information configuring the card to serve as a
redundant component.
Checking the Alarm and Link LEDs on the Optical (ATM/POS OC-3) Line Card
Each Optical (ATM) line card provides alarm LEDs for each of its four ports. These LEDs are located directly below
the fourth port, as illustrated in the figure below.
Figure 56. Alarm and Link LEDs on the Optical (ATM) Line Card
To Next Page
Loading...
Need help?
General
