Cisco ASR 5000 Series Installation Guide

Technical Specifications
Interface Specifications ▀
ASR 5000 Installation Guide ▄
271
Fast Ethernet Line Card (FLC2) Interfaces
Each of the eight RJ-45 interfaces available on the FLC2 supports auto-sensing 10Base-Tx or 100Base-Tx Ethernet
interfaces.
10/100 Mbps RJ-45 Interface
The RJ-45 interfaces on the Fast Ethernet line card support the following cable types and transfer rates. The following
figure shows the pin-outs for the RJ-45 Ethernet ports.
Table 96. FLC2 RJ-45 Ethernet Pinouts
Pin
10Base-T 10Mbps Cat3
100Base-TX 100Mbps Cat5
1
TX+
TX+
2
TX-
TX-
3
RX+
RX+
4
na
na
5
na
na
6
RX-
RX-
7
na
na
8
na
na
Gigabit Ethernet Card (GLC2/QGLC) SFP Interfaces
1000Base-SX
The 1000Base-SX fiber SFP interface on the Gigabit Ethernet Card (GLC2) has one pair of fiber connectors. The Quad
Gigabit Ethernet Card (QGLC) has four pairs.
Table 97. 100Base-SX Fiber Transmit and Receive Levels
Signal
Level
Max TX:
0 dBm
Min TX:
-9.5 dBm
Max RX:
0 dBm (saturation average power)
Min RX:
-20 (typical) / -17 (max.) dBm (sensitivity average power)

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English