Cisco ASR 5000 Series Installation Guide

Replacing Application Cards
▀ Removing the Application Card
▄ ASR 5000 Installation Guide
242
Removing the Application Card
This section describes how to remove an application card.
Important: Before you remove and replace an application card on an active system, refer to the System
Administration Guide for instructions on how to migrate or switch processes and services to a redundant (standby) card.
Step 1 Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the failed application card’s front panel.
Step 2 Slide the interlock switch on the front panel of the application card downward.
Caution: To minimize the risk of data loss, ensure that all LEDs on the packet processing card are Off
(extinguished) and that SMCs have stopped blinking prior to removing the card from the chassis.
Step 3 Pull the ejector levers outward, firmly and straight, until the card is unseated from the chassis.

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English